Wood screw EASYfast WAVE Countersunk head milling pockets, TX, Partial thread, Steel, electrogalvanized

Wood connections in engineered timber constructions such as wood frame constructions, pre-fabricated buildings, balcony constructions, staircase constructions

Countersunk head with milling pockets is suitable for applications in angles and fittings as well as for screwing directly in wood

• Patented countersunk head with milling pockets: combines the properties of a countersunk head and countersunk milling head and thereby reduces the demand of different head types. The milling pocket head works like a countersunk milling head in wood, but can also be used in fittings without damaging the coating
• Rib at the top: Reduces the spreading effect in wood, due to this, it is possible to screw-in near edges
• Strong thread flanks in the front part of the thread:
• Better wedging effect of the dowel. Due to this, higher pull-out-values can be achived
• Double thread: up to 50% faster screwing and thereby time saving. Increase of the productivity
• Shaft milling ribs and special sliding coating: Reduces driving torque especially when using long screws, due to this, screw-in-tools will be spared
• Recess/Drive: Very good bit fitting in combination with the Toko-Bit. Less wobbling and optimal power transmission from the bit to the drive due to matched and reduced tolerances.
• Drive-harmonization: Only one bit (TX20) for thread diameters of 3.5–5.0mm. For reasons of better power transmission, there exists a TX25 (diameter 5.0mm) for hardwood applications.
• European technical approval: ETA-12/2080 assures a maximum of safety for the EASYfast WAVE as a wood fastener