"Die-cuts stainless steel, iron, aluminium, copper and brass sheets as well as plastic, hard masonite, rubber, leather, VA sinks, fuse boxes, body parts, control cabinets, distribution boxes, dashboardsSuitable for steel sheets , stainless steel sheets, non-ferrous metals and light metals, plastics"

Priekšrocības:

"Quick, clean and burr-free perforationNo clamping of the stamping partOnly small deformation at the punched sheet metal part because of a 3-point cutting geometryNo bending of the traction bold due to a improved overlayPrecise adjustment of the punched hole because of a cross hair notch on the sheet hole templateQuick, easy, clean and burr-free punching of thin-walled materialsImproved overlay because of a 3-point first cut, therefore less deformation of the punched-out parts"

Apstrādes/lietošanas norādes

"(1) Drill hole with Ø 11 mm(2) Place the punch below the sheet, set the perforating die on the sheet and pre-install it with the attached clamp screw(3) Tighten the clamp screw with wrench SW 17 mm, until the complete plate punching machine can be removed from the material which should be perforated(4) Clean and burr-free holeCooling and lubricating increases the service life substantially"

Atsauksmes

(0)